瓦斯发电机组的选购以及使用之前的注意是怎样的呢？只有多多去了解相关的事项，才能更好更顺利更安全的操作机器，下面小编为您讲解一番吧。

What is the attention before choosing and using gas generator set? Only by learning more about relevant matters can we operate the machine better, more smoothly and more safely. The following editor will explain it to you.

瓦斯发电机组的选购注意

Notes on the purchase of gas generator set

1、瓦斯发电机组的界限尺寸、安装尺寸及连接尺寸均符合规定程序批准的厂品图样

1. The boundary dimension, installation dimension and connection dimension of the gas generator set shall comply with the factory product drawing approved by the specified procedure

2、机组的焊接应牢固，焊缝应均匀，无焊穿、咬边、夹渣及气孔等缺陷，焊渣焊药应清除干净；漆膜应均匀，无明显裂缝和脱落；镀层应光滑，无漏镀斑点、锈蚀等现象；机组紧固件应不松动。

2. The welding of the unit shall be firm, the welds shall be uniform, and there shall be no defects such as welding penetration, undercut, slag inclusion and pores, and the welding slag and flux shall be removed; The paint film shall be uniform without obvious cracks and falling off; The coating shall be smooth and free of missing spots, rust and other phenomena; The fasteners of the unit shall not be loose.

3、瓦斯发电机的电气安装应符合电路图，机组的各导线连接处应有不易脱落的明显标志。

3. The electrical installation of the gas generator shall comply with the circuit diagram, and the wire connections of the unit shall have obvious marks that are not easy to fall off.

4、瓦斯发电机应有接地良好的端子。

4. The gas generator shall have terminals with good grounding.

瓦斯发电机组使用之前的注意

Precautions before using gas generator set

瓦斯发电机组在启动前，先打开气源供气阀门，检查管路的连接是否可靠.如果管路中安装稳压罐，还应打开其底部的排污阀，放掉稳压罐中的污物，排净空气，关闭排污阀.向油底内加注机油至规定油面位置，向冷却系统的内加注冷却液，检查电动系统的电路连接是否正确，蓄电池电量是否充足.检查气路.

Before starting the gas generator set, open the gas supply valve to check whether the connection of the pipeline is reliable If a surge tank is installed in the pipeline, the blowdown valve at the bottom of the tank should also be opened, the dirt in the surge tank should be discharged, the air should be discharged, and the blowdown valve should be closed Fill the oil in the oil pan to the specified oil level, fill the coolant in the cooling system, check whether the circuit connection of the electric system is correct and whether the battery power is sufficient. Check the air circuit

检查燃气管路上的压力表指示是否正常，打开瓦斯发电机组的进气阀门，接通电源开关.使调速器怠速额定开关处于怠速状态起动发动机.待油温，水温分别升至45度，70度，油压高于0.245惭笔础，将瓦斯发电机组的升至高速工作.

Check whether the indication of the pressure gauge on the gas pipeline is normal, open the air inlet valve of the gas generator set, turn on the power switch, make the governor idle speed rated switch in the idle state, and start the engine. Wait until the oil temperature, the water temperature rises to 45 degrees and 70 degrees respectively, and the oil pressure is higher than 0.245Mpa, and then raise the Wasi generator set to high-speed operation

对新机或停放5天以上未使用的瓦斯发电机组，起前应盘动曲轴3-5转.对于平时停放作为应急用的瓦斯发电机组，为便于在急用时能迅速起动运行，停放期内，每隔3-5天试运行一次至水，油温度到60度以上.

For the new machine or the gas generator set that has not been used for more than 5 days, turn the crankshaft for 3-5 revolutions before starting For the gas generator set that is normally parked for emergency use, in order to quickly start and operate in case of emergency, the test run shall be conducted every 3-5 days during the parking period until the water and oil temperature reach more than 60 ℃

此外如果遇到发电机组出现了故障，操作人员不要慌，应镇静下来，仔细实时地根据故障发生的特征，判断其产生的原因在哪里。更多事项了解就来我们网站咨询吧。

In addition, if there is a fault in the generator set, the operator should not panic, should calm down and carefully determine the cause of the fault in real time according to the characteristics of the fault. Come to our website for more information Consult.